If your phone stand is blocking the IEEE switch, take note of the way cables are connected and disconnect them, then remove the stand.It is the connector labeled with an Ethernet port icon. Power the phone off by removing the Ethernet cord from the uppermost connection port as shown below.Turn the phone around so you're viewing the reverse side.If the switch is already on H/High, then you should reboot the phone by disconnecting and reconnecting the Ethernet cord (the one going from the wall port into the phone) and then skip to connecting the button module. To prepare your Avaya 9600 series deskphone to use the button module, you need to disconnect the phone from power, flip the phone's power to H/high by flipping the IEEE switch to H on the back of your phone, and then reconnect power to the phone. To order a button module, contact your communications liaison to submit an ICR. Reference the extension on the phone and any line appearances to be configured on the button module. To request that the phone be configured to support a button module. You must contact NI&S for configuration when connecting a button module in order for it to work.
0 kommentar(er)
